Logo

P3833 Engine Code Repair

Meaning of P3833 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P3833 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P3833 code is occuring now you should check P3833 repair processes.
Now don't ask yourself; What should you do with P3833 code ?
The solution is here :

P3833 Possible Solution:

P3833 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P3833 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

3
Ignition System Or Misfire

8
Fuel Rail Pressure Sensor Circuit Malfunction

3
Turbocharger Boost Sensor A Circuit Low

3
Glow Plug/Heater Circuit 'A' Malfunction

Regarding the P3833 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P3833 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P3833 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For P3833 Code

The reason of P3833 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

P3833 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.